Commercial Roofing · Jeffersonville, KY

Jeffersonville Commercial Roofing Contractor

Reflash Service Masts, Conduit Supports, and Rooftop Unit Curbs

Choose a Jeffersonville commercial roofing contractor who plans the rooftop electrical work, from unit disconnects to service masts, before the tear-off starts.

Roofers installing metal panels on a commercial building

Your First Visit

  1. Inspect Your Roof
  2. Written Scope
  3. Pick The System
  4. Work Around Your Hours

Rooftop Electrical

Electrical Work During a Jeffersonville Roof Replacement

A Jeffersonville commercial roofing contractor runs into electrical items on nearly every replacement. Rooftop units get disconnected while curbs are rebuilt, conduit strapped across the old roof moves onto new supports, and service masts through the deck get new flashing boots.

Electrical inspection goes to the city or to the Montgomery County Judge Executive, depending on whether the building sits inside city limits. Building permits stay with the Kentucky HBC.

  • Check city or county status on the tax bill before wiring work.
  • Unit disconnects are timed with your HVAC service company.
  • Service masts get new boots sized to the finished roof.
Aerial view of a large industrial roof with a crew at work

Signs To Watch

Commercial Roofing Problems on Jeffersonville Rooftops

Leaks around equipment and wiring are the most common reason Jeffersonville owners call.

From The Parking Lot

Mast Leaning Or Loose

A service mast pulling at its roof boot after storms.

Rusting Coping Near Units

Edge metal stained where unit condensate runs off.

Inside The Building

Water At Light Fixtures

Drips at fixtures under conduit runs or roof penetrations.

Leaks Below Units

Stains on the ceiling right under a rooftop unit.

On The Roof

Conduit Straps Through The Sheet

Old straps screwed through the membrane instead of resting on supports.

Cracked Pitch Pans

Dried filler around wiring penetrations letting water down the conduit.

Benefits

Benefits of Planning Rooftop Wiring Into the Re-Roof

Electrical items handled up front keep the roof crew and the electrician from waiting on each other.

The Main One

Every Penetration Flashed Once

When masts, conduit, and unit wiring are moved or disconnected on schedule, each penetration gets its boot or curb flashing in the same pass as the new membrane, with no second trip to cut it back open.

Supports, Not Screws

Conduit rides on pads instead of straps through the sheet.

Taller Unit Curbs

Curbs rebuilt during the disconnect window get full flashing height.

Right Inspector

City or county status is settled before any wiring on the roof moves.

Roof Options

Commercial Roofing Options for Jeffersonville

The roof system follows the building; the electrical plan follows the roof.

Roofing crew working on a white TPO membrane roof

TPO With Rebuilt Unit Curbs

Welded TPO roofing flashes cleanly up new curbs and around mast boots.

Fits: Low-slope buildings with several rooftop units.

Roofer walking a low-slope commercial roof during an inspection

Penetration And Flashing Repair

Targeted commercial roof repair replaces cracked pitch pans and boots when the field is still dry.

Fits: Roofs with leaks only at wiring and equipment.

Crew working on a black EPDM rubber roof

Metal Panels With New Curb Penetrations

Metal roofing over retrofit framing gets new curbs that rise through the panel plane.

Fits: Shops and warehouses with exposed-fastener roofs.

Leak Right Under a Rooftop Unit?

Call and tell us which unit, who services it, and whether wiring or conduit runs nearby. That shapes who needs to be on the roof with us.

Re-Roof Steps

How a Jeffersonville Commercial Roofing Contractor Sequences the Work

Roof and electrical steps are lined up so neither waits on the other.

  1. Inspect Your Roof

    We map every unit, mast, conduit run, and penetration, check how each one is flashed, and take core cuts to see whether the insulation is dry. Curb heights are measured against the new roof height.

  2. Settle Permits And Inspectors

    The roof permit goes to the Kentucky HBC. Electrical inspection is lined up with the city or county based on the parcel.

  3. Schedule Disconnects

    Units are shut down with the HVAC company, conduit is lifted, and the electrician is booked for the days curbs and masts are reworked.

  4. Roof, Flash, Reconnect

    New membrane goes down, curbs and mast boots are flashed, conduit returns on supports, and units are reconnected and checked.

Nearby Towns

Nearby Towns We Work In Around Jeffersonville

Commercial roofing work reaches Jeffersonville plus Winchester, Mount Sterling, Carlisle, Owingsville, and Camargo.

Not in one of these towns? You can call us or send us a message.

Crew tearing an old commercial roof down to the deck

Winchester, Our Home Base

  • One permit office handles both city and county parcels in Clark County.
  • Moving conduit or unhooking a unit can add an electrical permit.
  • Lot work for crane staging also goes through the city office.
Winchester commercial roofing
Roofing work truck parked beside a commercial building

Commercial Roofing in Mount Sterling

  • Insulation levels get confirmed before ordering materials.
  • Drain extensions follow the finished roof height.
  • Edge metal is set after the insulation is down.
Mount Sterling commercial roofing
Carlisle

Commercial Roofing in Carlisle

  • Two co-ops serve Nicholas County; the bill names yours.
  • Service drops near the eave shape gutter replacement.
  • Building permits come from the Kentucky HBC.
Carlisle commercial roofing
Owingsville

Commercial Roofing in Owingsville

  • A downtown storefront and a county-road shop follow different paths.
  • Wiring changes go to the city or the County Judge Executive.
  • The tax bill shows which side of the line you are on.
Owingsville commercial roofing
Camargo

Commercial Roofing in Camargo

  • The utility named on the bill gets a call before tear-off.
  • Overhead lines near the building shape the staging plan.
  • Montgomery County relies on the state for building permits.
Camargo commercial roofing

Jeffersonville FAQ

Jeffersonville Commercial Roofing Questions Answered

How is electrical work handled during a Jeffersonville roof replacement?

Electrical inspection goes to the city when the building is inside city limits and to the Montgomery County Judge Executive when it is not, while the building permit stays with the Kentucky HBC. Electrical work during a Jeffersonville roof replacement usually means unit disconnects, conduit moved to new supports, and new boots on service masts.

Who disconnects rooftop units during a re-roof?

Your HVAC service company or an electrician, whichever services that unit and its wiring. We schedule the disconnect for the days its curb is rebuilt, then the unit is reconnected and checked once the new flashing is done.

Why does conduit move during a commercial roof replacement in Jeffersonville, KY?

Old conduit is often strapped straight through the membrane or laid on the roof. During replacement it is lifted, the new roof goes down, and the conduit returns on supports set on pads, so straps no longer puncture the sheet.

What permit covers the roof itself in Jeffersonville?

The Kentucky HBC, since Montgomery County relies on the state for building permits. A Jeffersonville commercial roof permit request should list the roof area, system, insulation, deck repair, and any new curbs.

Can leaks at equipment be fixed without a full replacement?

Often, yes, when the rest of the field is dry. Cracked pitch pans, split boots, and failed curb sealant are repaired with matching material. Core cuts around the leak show whether water has spread into the insulation.

Should the HVAC company be on the roof during the re-roof?

For the days a unit is disconnected and its curb rebuilt, yes. The service company shuts the unit down, the curb is raised and flashed to the new roof height, and the unit is reconnected and checked. Setting those dates early keeps the building comfortable and the crew moving.

Call a Jeffersonville Commercial Roofing Contractor

Tell us what equipment sits on the roof. We plan the re-roof and the electrical steps together.

Call Us (513) 756-8349